ADJUSTMENT STEP 1
Program the Travel Limits
Travel limits regulate the points at which the door will stop when moving up or down. Follow the steps below to set the limits.
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door.
•Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
•After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
Figure 1 | Black | Indicator |
Light | ||
| Button |
|
To prevent damage to vehicles, be sure fully open door provides adequate clearance.
Antenna | Purple |
Button |
To program the travel limits:
1.Press and hold the black button until the yellow indicator light starts flashing slowly then release.
2.Push and hold the black button until the door reaches the desired UP (open) position (Figure 2). Adjust the position of the door by using the black and purple buttons. Black moves the door UP (open) and purple moves the door DOWN (close).
Check to be sure the door opens high enough for your vehicle.
NOTE: Refer to previous page for correct door position for
3.Push the remote control or door control (Figure 3). This sets the UP (open) limit and begins closing the door. Immediately press either the black or purple button; the door will stop.
Adjust the desired DOWN (close) limit position using the black and purple buttons (Figure 4). Check to be sure the door is fully closed without applying excessive pressure on the rail (rail should not bow upwards and the belt should not sag or droop below the rail). Push the remote control or door control (Figure 3). This sets the DOWN (close) limit and begins opening the door.
Figure 2
Push and hold |
|
| |
until the door | BLACK | PURPLE | |
is at desired UP | |||
|
| ||
position |
|
|
Figure 4
|
| Push either | |
BLACK | PURPLE | button to stop | |
door at desired | |||
|
| ||
|
| DOWN position |
4.Open and close the door with the remote control or door control 2 or 3 times.
If the door stops in both the desired UP (open) and DOWN (close) positions, proceed to Adjustment Step 2, Setting the Force, followed by Adjustment Step 3, Test the Safety Reversal System.
Figure 3
or
LOCK
LIGHT
27