Chamberlain HD800D Carton Inventory

Carton Inventory

Your garage door opener is packaged in one carton which contains the motor unit and all parts illustrated below. Accessories will depend on the model purchased. If anything is missing, carefully check the packing material.

Parts may be stuck in the foam. Hardware for assembly and installation is shown on the next page. Save the carton and packing material until installation and adjustment is complete.

LOCK

LIGHT

Motion Detecting

Door Control Panel

Battery Backup Unit

Belt Cap Retainer

Motor Unit with Light Lens

Idler Pulley

Rail

Front (header)

Section

Header Bracket

Remote Control

Transmitter Visor Clip

SECURITY✚®

3-Button Remote Control (2)

Trolley

Rail

Center/Back

Sections

"U" Bracket

Belt

Curved Door

Arm Section

Door Bracket

2-Conductor Bell Wire

White & White/Red

SECURITY✚®

Keyless Entry

Hanging Bracket

			The Protector System®	Safety Labels
	Safety Sensor		The Protector System®
	Safety Sensor		(2) Safety Reversing Sensors
	Bracket (2)		(2) Safety Reversing Sensors	and
	Bracket (2)		(1 Sending Eye and 1 Receiving Eye)	and
			(1 Sending Eye and 1 Receiving Eye)	Literature
			with 2-Conductor White & White/Black	Literature
			with 2-Conductor White & White/Black
			Bell Wire attached

Straight Door Arm Section

6

Contents

For Residential Use Only Introduction Assembly Installation Adjustment Operation Preparing your garage door Tools needed Planning Planning (Continued) Carton Inventory Hardware Inventory Assemble the Rail & Install the Trolley Fasten the Rail to the Motor Unit Install the Idler Pulley Install the Belt and Attach the Belt Cap Retainer Set the Tension Determine the Header Bracket Location Install the Header Bracket Attach the Rail to the Header Bracket Position the Opener Hang the Opener Install the Door Control Install the Lights Attach the Emergency Release Rope and Handle Electrical Requirements Install The Protector System® INSTALLING THE BRACKETS Garage door track installation (preferred): Wall installation (Figure 2 & 3): Floor installation (Figure 4): MOUNTING AND WIRING THE SAFETY REVERSING SENSORS ALIGNING THE SAFETY REVERSING SENSORS TROUBLESHOOTING THE SAFETY REVERSING SENSORS Fasten the Door Bracket ONE-PIECEDOORS Metal Doors: Connect Door Arm to Trolley ALL ONE-PIECEDOORS 1.Assemble the Door Arm: Program the Travel Limits Setting the Force Test the Safety Reversal System Test The Protector System® Using Your Garage Door Opener Using the Wall-MountedDoor Control To Open the Door Manually BATTERY BACKUP UNIT 1. Mounting the BBU Directly to the Motor Unit 2.Mounting the BBU Directly to the Ceiling Structural Support 3. Connect the BBU to the Motor Unit IMPORTANT NOTE: OPERATING INSTRUCTIONS 1. Test the installed BBU with the motor unit 2. Charge the battery Battery Backup Unit (BBU) Diagnostics GREEN LED: CARE OF YOUR OPENER MAINTENANCE SCHEDULE Once a Month THE REMOTE CONTROL BATTERY Once a Year HAVING A PROBLEM The opener doesn't operate from either the Door Control or the remote control: 2.Opener operates from the remote, but not from the Door Control: 3.The door operates from the Door Control, but not from the remote control: 4. The remote control has short range: 1 FLASH 2 FLASHES 3 FLASHES 4 FLASHES 5 FLASHES To Add or Reprogram a Hand-heldRemote Control To Erase All Codes From Motor Unit Memory *3-ButtonRemotes To Add, Reprogram or Change a Keyless Entry PIN Rail Assembly Parts Installation Parts Motor Unit Assembly Parts ACCESSORIES 953D 3-ButtonSECURITY✚® Remote 7702CB Control: Page Page CHAMBERLAIN® THREE YEAR LIMITED WARRANTY 10 YEAR BELT LIMITED WARRANTY & LIFETIME MOTOR LIMITED WARRANTY