14TESTING THE SAFETY REVERSE SYSTEM
The safety reverse system test is important. |
|
The garage door must reverse on contact |
|
with a 40 mm obstacle laid flat on the floor. |
|
Failure to properly adjust the opener may result in |
|
serious personal injury from a closing garage |
|
door. | 40 mm |
| |
Operate the door in the down direction. The door must |
|
reverse upon contact with the obstacle. If the |
|
stops on the obstacle, remove obstacle and |
|
limit and force setting (refer section 13). | 40 mm Test obstacle |
|
Repeat test of the safety reverse system.
15FIXING WARNING LABELS
Once you have completed your installation and successfully carried out the safety reverse system test (outlined above), install the warning labels provided with your opener as shown.
The risk of entrapment label must be installed adjacent to the release handle at a height of less than 1.8 m from the floor.
Handle should be less than 1.8 m
The WARNING label must be installed in a prominent place near any fixed control.
Any fixed wall control or wireless door control must be mounted at a height of no less thanout1.5 mof the
reach of children.
Ensure the manual release instruction card is attached to the rope as detailed in section 7.
Read the safety instructions (page 1) for further details concerning safety.
Wall control, or wireless push button no less than 1.5 m
>1.5 m
<1.8 m
STANDARD INSTALLATION COMPLETE
8