Chamberlain MT60P manual Operation of Your Opener

OPERATION OF YOUR OPENER		SPECIFICATIONS
		Input Voltage	230-240 VAC, 50Hz
Your opener can be activated by any of the followingMaxdevices:. Pull Force			22
			600N
• The Motion Detecting Control Panel. Hold the button		Power	100W
down until door starts to move.		Standby Power	3 watt (nominal)
•The Outside Keyswitch or Keyless Entry System	(if you	Normal Torque	5Nm
have installed either of these accessories).		Max door weight	70kgs - spring balanced

•The Transmitter. Hold the push button down until the door

Motor

starts to move.	Type	DC gearmotor permanent lubrication
Opening the Door Manually: Door should be fully closed	Drive Mechanism
if possible. Weak or broken springs could allow an open
	Drive	Chain with two-piece trolley on steel pole.
door to fall rapidly. Property damage or serious personal
	Length of Travel	Adjustable to 2750mm (3.0m Pole)
injury could result.
		2500mm (2.75m Pole)
The door can be opened manually by pulling the release
	Minimum Travel Length...1.1m
handle down. To reconnect the door, pull the releaseTravelhandleRate		127-178mm per second
down and toward the opener.	Lamp	On when door starts, off 2-1/2 minutes
Do not use the manual release handle to pull the door		after stop (BA15s, 24V/21W)
opener or closed. When the Opener is Activated by	Door Linkage	Adjustable door arm. Pull cord trolley release
Transmitter or Lighted Door Control Button:	Safety
1. If open, the door will close. If closed, the door willPersonalpen		Push button stopUP andinDOWN
2. If closing, the door will stop.		direction. Automatic safety reverseDOWN in
3. If opening, the door will stop (allowing space for entry and		direction and stopUP. in
		Automatic force adjustment
exit of pets and for fresh air).	Electronic
	Electrical	Transformer overload protector and low
4. If the door has been stopped in a partially open or closed		voltage push button wiring.
position, it will reverse direction.
	Limit Device	Optical RPM/Passpoint detector.
5. If an obstruction is encountered while closing, the door will		Electronic, Semi and Fully Automatic.
reverse.	Limit Adjustment
	Start Circuit	Low voltage push button circuit.
6. If an obstruction is encountered while opening, the door will
reverse and stop.	Dimensions
	Length (Overall)	3290mm (3.0m pole)
7. The optional Protector System™ uses an invisible beam		3040mm (2.75m pole)
which, when broken by an obstruction, causes a closing
		60mm
	Headroom Required
door to open and prevents an open door from closing. It is		10.5kg
STRONGLY RECOMMENDED for homeowners with young	Hanging Weight
	Receiver
children.
	Memory Registers	12
Allow a 15 minute cooling period after 5 continuous
	Operating Frequency	433.92MHz
operations of the openerThe opener. light will turn on: 1.
when opener is initially plugged in; 2. when the power is
briefly interrupted; 3. when the opener is activated.
The light turns off automatically after 2-1/2 minutes. Bulb size
is 24V/21W maximum.

SPECIAL NOTE: Chamberlain strongly recommends that the Protector System TM be installed on all garage door openers.