8
2
1
2
1
Pole
Door 50mmspacer should
beused to determine
thecorrect mounting
position
Header
Bracket50mm (2”)
abovethe highest
pointof travel
Header
Bracket
50mmspacer should
beused to determine
thecorrect mounting
position
50mm(2”)
abovethe highest
pointof travel
Door
Pole
100mmspacer should
beused to determine
thecorrect mounting
position
Door
Header
200mm(8”)
abovethe highest
pointof travel
Bracket
Pole
Youwill need a 50mm piece of timber or similar
spacer to gauge the distance between door and pole.
1. Raise the opener onto support.
2. Open the door completely,place a 50mm
spacer between the door and the pole
(as shown).
3. If the top section or panel hits the trolley when
you raise the door,pull down on the trolley arm
to disengage the opener.Leave the trolley in this
position until opener is fastened in place.
ONE PIECE TILT DOORYouwill need a 100mm (4”) piece of timber or similar
spacer to gauge the distance between door and pole.
1. Raise the opener onto support.
2. Open the door completely,place a 100mm
spacer between the door and the pole
(as shown).
3. The top of the door should be level with the top
of the opener.Do not position the opener more
than 50mm (2”) above this point.
15
ATTACHPOLE ASSEMBLY TO HEADERBRACKETPosition opener on garage floor below the
header bracket. Use packing material to protect
the cover.
NOTE: To enable the pole to clear sectional
door springs, it may be necessary to lift
opener onto a temporary support. The opener
must either be secured to a support or held
firmly in place by another person. Raise Pole
assembly until chain pulley and header
brackets come together. Join with clevis pin
(1). Insert R-clip (2) to secure.
14