INSTALLING THE LIGHT BULB(S)

1 Flex Sides of Light Lens to Remove Lens from Tabs

To prevent possible OVERHEATING of the endpanel or light socket:

•DO NOT use short neck or specialty light bulbs.

•DO NOT use halogen bulbs. Use ONLY incandescent.

To prevent damage to the opener:

•DO NOT use bulbs larger than 100W.

•ONLY use A19 size bulbs.

2 Rotate Light Lens Down

3 Install Standard Light Bulb(s)

 

(100W max) into Socket(s)

 

100 Watt (Max)

 

Standard Light Bulb

ELECTRICAL REQUIREMENTS

NOTE: Plug motor unit into grounded power outlet. If a grounded outlet is not available, contact a qualified electrician to install a proper outlet.

Plug Motor Unit into Power Outlet

To prevent possible SERIOUS INJURY or DEATH from electrocution or fire:

•Be sure power is NOT connected to the opener, and disconnect power to circuit BEFORE removing cover to establish permanent wiring connection.

•Garage door installation and wiring MUST be in compliance with ALL local electrical and building codes.

•NEVER use an extension cord, 2-wire adapter, or change plug in ANY way to make it fit outlet. Be sure the opener is grounded.

RIGHTWRONG

OR

If permanent wiring is required by your local code, follow procedure below. Disconnect power to the circuit before removing cover to establish permanent wiring connections.

1 Remove Motor Unit

2 Remove Power Cord

3

Run Wire from

4 Replace Motor Unit

Screws and Cover

 

 

 

 

Outlet to Motor Unit

Cover and Screws

 

Ground

Black

 

 

Ground

 

 

Wire

 

 

 

 

Wire

Green

 

Tab

 

 

 

 

 

 

 

 

Ground

 

 

 

 

 

 

Screw

 

 

 

 

 

 

 

 

Black

 

 

 

 

Ground

Wire

 

 

 

 

Wire

 

 

 

 

White Wire

 

 

 

 

 

 

 

Black

 

 

 

Black

 

 

Wire

 

 

White Wire

 

 

 

 

 

Wire

 

 

 

 

 

 

16