
Using the Wall-Mounted Door Control
To Open the Door Manually
THE MULTI-FUNCTION DOOR CONTROL
Press the lighted push button to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.
LOCK
LIGHT
Push Button
Lock
Button
Light
Button
WARNING
To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
• If possible, use emergency release handle to |
disengage trolley ONLY when garage door is CLOSED. |
Weak or broken springs or unbalanced door could |
result in an open door falling rapidly and/or |
unexpectedly. |
Light feature
Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for
• | NEVER use emergency release handle unless garage |
| doorway is clear of persons and obstructions. |
• | NEVER use handle to pull door open or closed. If rope |
| knot becomes untied, you could fall. |
DISCONNECT THE TROLLEY:
until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to
Lock feature
Designed to prevent operation of the door from
To activate, press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on.
The door should be fully closed if possible. Pull down on the emergency release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually. The lockout feature prevents the trolley from reconnecting automatically, and the door can be raised and lowered manually as often as necessary.
Trolley
Trolley
Release Arm
(In Manual
Disconnect
Position)
NOTICE
Lockout position (Manual disconnect)
To turn off, press and hold the Lock button again for 2 seconds. The push button light will stop flashing. The Lock feature will also turn off whenever the “learn” button on the motor unit panel is activated.
Additional feature when used with the 3-Button hand-held remote
To control the opener lights:
In addition to operating the door, you may program the remote to operate the lights.
1.With the door closed, press and hold a small remote button that you want to control the light.
2.Press and hold the Light button on the door control.
3.While holding the Light button, press and hold the Lock button on the door control.
4.After the opener lights flash, release all buttons.
TO RE-CONNECT THE TROLLEY:
Pull the emergency release handle toward the opener at an angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either manually or by using the door control or remote.
Trolley
| Trolley |
| Release |
| Arm |
Emergency |
|
Release Handle |
|
(Down and Back) | NOTICE |
|
To reconnect
31