Chamberlain WD952KD, WD952LD Carton Inventory

Carton Inventory

Your garage door opener is packaged in one carton which contains the motor unit and all parts illustrated below. Accessories will depend on the model purchased. If anything is missing, carefully check the

packing material. Parts may be stuck in the foam. Hardware for assembly and installation is shown on the next page. Save the carton and packing material until installation and adjustment is complete.

Remote Control

Transmitter Visor Clip

SECURITY®

3-Button Remote Control (2)

Motion Detecting

Door Control Panel

Battery Backup Unit

Trolley

Belt Cap Retainer

		Rail
	Motor Unit with Light Lens	Center/Back
	Motor Unit with Light Lens	Sections
		Sections

Idler Pulley

"U" Bracket

Belt

Rail

Front (header)

Section

Curved Door

Arm Section

Header Bracket

Door Bracket

		2-Conductor Bell Wire
		White & White/Red
Safety Sensor	(2) Safety Reversing Sensors	Safety Labels
Bracket (2)	(1 Sending Eye and 1 Receiving Eye)	and
	with 2-Conductor White & White/Black	Literature
	Bell Wire attached

SECURITY®

Keyless Entry

Hanging Bracket

Straight Door

Arm Section

6

Contents

For Residential Use Only Introduction Assembly Installation Adjustment Operation Preparing your garage door Tools needed Planning Planning (Continued) Carton Inventory Hardware Inventory Assemble the Rail & Install the Trolley Fasten the Rail to the Motor Unit Install the Idler Pulley Install the Belt and Attach the Belt Cap Retainer Set the Tension Determine the Header Bracket Location Install the Header Bracket Attach the Rail to the Header Bracket Position the Opener Hang the Opener Install the Door Control Install the Lights Attach the Emergency Release Rope and Handle Electrical Requirements Install The Protector System® INSTALLING THE BRACKETS Garage door track installation (preferred): Wall installation (Figure 2 & 3): Floor installation (Figure 4): MOUNTING AND WIRING THE SAFETY SENSORS ALIGNING THE SAFETY SENSORS TROUBLESHOOTING THE SAFETY SENSORS Fasten the Door Bracket ONE-PIECEDOORS Metal Doors: Connect Door Arm to Trolley ALL ONE-PIECEDOORS 1.Assemble the Door Arm: Program the Travel Limits Setting the Force Test the Safety Reversal System Test The Protector System® Using Your Garage Door Opener Using the Wall-MountedDoor Control To Open the Door Manually BATTERY BACKUP UNIT 2.Mounting the BBU Directly to the Ceiling Structural Support 1. Mounting the BBU Directly to the Motor Unit 3. Connect the BBU to the Motor Unit IMPORTANT NOTE: OPERATING INSTRUCTIONS 1. Test the installed BBU with the motor unit 2. Charge the battery Battery Backup Unit (BBU) Diagnostics GREEN LED: CARE OF YOUR OPENER MAINTENANCE SCHEDULE Once a Month THE REMOTE CONTROL BATTERY Once a Year HAVING A PROBLEM My door will not close and the light bulbs blink on my motor unit: 2.My remotes will not activate the door: My door reverses for no apparent reason: 5.My lights will not turn off when door is open: 1 FLASH 2 FLASHES 3 FLASHES 4 FLASHES 5 FLASHES To Add or Reprogram a Hand-heldRemote Control To Erase All Codes From Motor Unit Memory *3-ButtonRemotes To Add, Reprogram or Change a Keyless Entry PIN Rail Assembly Parts Installation Parts Motor Unit Assembly Parts ACCESSORIES 953D 3-ButtonSECURITY✚® Remote 7702CB Outside Quick Release: Page Page CHAMBERLAIN® ONE-YEARLIMITED WARRANTY 10 YEAR BELT LIMITED WARRANTY & LIFETIME MOTOR LIMITED WARRANTY