Chamberlain WD962KD, WD962KLD NOTE:, Wood Doors:, Metal Doors:, ONE-PIECEDOORS

ONE-PIECE DOORS

Please read and comply with the warnings and reinforcement instructions on the previous page. They apply to one-piece doors also.

•	Center the door bracket on the top of the door, in line
	with the header bracket as shown. Mark either the left
	and right, or the top and bottom holes.
•	Metal Doors: Drill 3/16" pilot holes and fasten the
	bracket with the 1/4"-14x5/8" self-threading screws
		HARDWARE SHOWN
	provided.
			ACTUAL SIZE
•	Wood Doors: Drill 5/16" holes and use 5/16"x2"
	carriage bolts, lock washers and nuts (not provided)
	or 5/16"x1-1/2" lag screws (not provided) depending
	on your installation needs.
		Self-Threading Screw
NOTE: The door bracket may be installed on the top		1/4"-14x5/8"
edge of the door if required for your installation. (Refer to
the dotted line optional placement drawing.)

			Self-Threading
			Screw
		Door	1/4"-14x5/8"
Header Wall
	Finished Ceiling	Bracket	Top of Door
2x4 Support
			(Inside Garage)
			Top Edge
			of Door
Header
Bracket
			Optional
			Placement
Door
Bracket
			METAL DOOR
Optional	HORIZONTAL AND VERTICAL
Placement			Lock
	REINFORCEMENT IS NEEDED	Nut
of Door
Bracket	FOR LIGHTWEIGHT GARAGE	5/16"-18	Washer
	DOORS (FIBERGLASS,		5/16"
	ALUMINUM, STEEL, DOORS		Top of Door
	WITH GLASS PANEL, ETC.).	Door
Vertical	(NOT PROVIDED)	Bracket	(Inside Garage)
Centerline of
Garage Door			Top Edge
			of Door
			Optional
			Placement
			Carriage Bolt
			5/16"x2"
			(Not Provided)

For a door with no exposed framing,	WOOD DOOR
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.

25