INSTALLATION STEP 7
Install the Battery Backup
• Make sure motor unit is unplugged. | |
• | Using a Phillips head screwdriver, remove the battery |
| cover on the motor unit. |
• | Partially insert battery into motor unit with terminals |
| facing out. |
ALWAYS wear protective gloves and eye protection when changing the battery or working around the battery compartment.
• Connect the red (+) and black | |
| to corresponding terminals on battery. |
• | Verify the battery wires are seated in the channel. |
• | Replace battery cover. |
INSTALLATION STEP 8
Channel
Battery
Battery Cover
Install the Lights
•Press the release tabs on both sides of lens. Gently rotate lens back and downward until the lens hinge is in the fully open position. Do not remove the lens.
•Install a 100 watt maximum light bulb in each socket. Light bulb size should be A19, standard neck only. The lights will turn ON and remain lit for approximately
•Reverse the procedure to close the lens.
•Use A19, standard neck garage door opener bulbs for replacement.
NOTE: Use only standard light bulbs. The use of short neck or speciality light bulbs may overheat the endpanel or light socket.
To prevent possible OVERHEATING of the endpanel or light socket:
•DO NOT use short neck or specialty light bulbs.
•DO NOT use halogen bulbs. Use ONLY incandescent. To prevent damage to the opener:
•DO NOT use bulbs larger than 100W.
•ONLY use A19 size bulbs.
100 Watt (Max)
Standard Light Bulb
Release Tab
Lens
100 Watt (Max)Hinge
Standard Light Bulb
18