Tripp Lite RMX 1000-2000 VA owner manual Basic Operation continued, Indicator Lights Front Panel

200208099 93-2040 SM1000RMX Owner’s Manual.qxd 9/12/2002 3:53 PM Page 8

Basic Operation continued

Indicator Lights (Front Panel)

POWER: Lights green when the UPS is receiving AC power. Illuminates constantly when the UPS is in the ON mode, indicating that batteries are charging and connected equipment is receiving filtered AC power. Flashes while in STANDBY mode to indicate that batteries are charging but connected equipment is not receiving power.

VOLTAGE CORRECTION: Lights green whenever your UPS is automatically correcting high or low AC line voltage. The UPS will also click. These are normal, automatic UPS operations, and no action is required on your part.

BATTERY CHARGE: This multicolored light displays 7 separate UPS battery charge conditions. It will turn from red (low) to yellow (medium) to green (full) to show you the level of battery charge. If the light is constant, your UPS is in the ON or STANDBY mode, operating from line power, and the battery is charging. If the light is flashing, your UPS is in the INVERT mode, operating from battery, and the battery is discharging. If the light is flashing red, your UPS is in INVERT and is nearly out of power: you should save files and shut down your equipment immediately.

OUTPUT LOAD: This multicolored light shows how heavy your UPS’s load is. Steady green indicates a light load, steady yellow a medium load. When the light is red, your UPS is supporting a load above 85% of its capacity. If the red light begins flashing, then your UPS is severely overloaded. Immediately remove load from the UPS until the light stops flashing.

BATTERY WARNING: Lights red if your UPS’s self-test (initiated with the Mute/Test Switch) reveals a low battery charge or internal fault. If this light turns on, let the UPS charge for 12 hours then perform a second self-test. If the light stays on, contact Tripp Lite for service.

Other UPS Features (Rear Panel)

15 amp NEMA 5-15R

AC Receptacles:Your UPS has 15-amp outlets that provide 120V AC power. These output receptacles supply your connected equipment with AC line power during normal operation and battery power during blackouts and brownouts. The UPS protects equipment connected to these receptacles against damaging surges and line noise. If you have a DB9 or USB connection to your UPS, you can remotely reboot con- nected equipment by turning the UPS OFF and ON using Tripp Lite’s PowerAlert Software. See software instructions for details.

8