Onkyo HT-r591 instruction manual En-29, Error Messages, Changing the Speaker Setup Manually

Models: HT-r591

1 80
Download 80 pages 42.27 Kb
Page 29
Image 29
Error Messages

Error Messages

While Audyssey 2EQ® Room Correction and Speaker Setup is in progress, one of the error messages below may appear.

2EQ: Auto Setup

Audyssey

Ambient noise is too high. Changing the Speaker Setup Manually Error message

Retry

Cancel

The options are:

`Retry:

Try again.

`Cancel:

Cancel Audyssey 2EQ Room Correction and Speaker Setup.

• Ambient noise is too high.

The background noise is too loud. Remove the source of the noise and try again.

• Speaker Matching Error!

The number of speakers detected was different from that of the first measurement. Check the speaker connection.

• Writing Error!

This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact your Onkyo dealer.

• Speaker Detect Error

This message appears if a speaker is not detected. “No” means that no speaker was detected.

Tip

See “Speaker Configuration” for appropriate settings (page 12).

Turning On & Basic Operations

Changing the Speaker Setup Manually

You can manually make changes to the settings found during Audyssey 2EQ Room Correction and Speaker Setup.

See also:

“Sp Config (Speaker Configuration)” (page 42)

“Sp Distance (Speaker Distance)” (page 43)

“Level Cal (Level Calibration)” (page 44)

Using a Powered Subwoofer

If you’re using a powered subwoofer and it outputs very low-frequency sound at a low volume level, it may not be detected by Audyssey 2EQ Room Correction and Speaker Setup.

If the “Subwoofer” appears on the “Review Speaker Configuration” screen as “No”, increase the subwoofer’s volume to the half-way point, set it to its highest crossover frequency, and then try running Audyssey 2EQ Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, detection issues may occur, so use an appropriate volume level. If the subwoofer has a low-pass filter switch, set it to Off or Direct. Refer to your subwoofer’s instruction manual for details.

En-29

Page 29
Image 29
Onkyo HT-r591 instruction manual En-29, Error Messages, Changing the Speaker Setup Manually, Using a Powered Subwoofer