Onkyo HT-r591 En-35, Using the Home Menu, Using the Sleep Timer, Input, Audio, Info*1

Using the Home Menu

The Home menu provides quick access to frequently used settings. You can change settings and view the current information.

The on-screen menus appear only on a TV that is connected to the HDMI OUT. If your TV is connected to other video outputs, use the AV receiver’s display when changing settings.

Note

•The on-screen menus are displayed when:

–There is no video input, or

–The video input is 480p, 576p, 720p, 1080i, or 1080p.

1	Press RECEIVER followed by HOME.
	The Home menu will be superimposed on the TV
	screen.
2	Use q/wand ENTER to make the desired selection.
	■ Input
	`You can select the input source.

Use q/wto select the desired input source. Pressing ENTER switches to the selected input source.

■Audio

`You can change the following settings: “Bass”, “Treble”, “Subwoofer Level”, “Center Level”, “Audyssey”, “Dynamic EQ”,

“Dynamic Volume”, “Late Night”, “Music Optimizer”, and “Cinema Filter”.

See also:

•“Audyssey” (➔ page 46)

•“Using the Audio Settings” (➔ page 50)

■Info*1

`You can view the information of the following items: “Input” and “Output”.

■Listening Mode*2

`You can select the listening modes that are grouped in the following categories: “MOVIE/TV”, “MUSIC” and “GAME”.

Use q/wto select the category and e/rto select the listening mode. Press ENTER to switch to the selected listening mode.

Note

*1 Depending on the input source and listening mode, not all channels shown here output the sound.

*2 • This setting is not available in either of the following cases: –The “Audio TV Out” setting is set to “On” (➔ page 50). –“HDMI Ctrl (RIHD)” is set to “On” (➔ page 49) and

you’re listening through your TV speakers.

Turning On & Basic Operations

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to turn off automatically after a specified period.

1 Press RECEIVER once followed by SLEEP repeatedly to select the required sleep time.

The sleep time can be set from 90 to 10 minutes in 10 minute steps.

The SLEEP indicator lights on the AV receiver’s display when the sleep timer has been set. The specified sleep time appears for about 5 seconds, then the previous display reappears.

Tip

•If you need to cancel the sleep timer, press SLEEP repeatedly until the SLEEP indicator goes off.

•To check the time remaining until the AV receiver sleeps, press SLEEP. Note that if you press again on SLEEP as the time being displayed is equal to 10 minutes or less, the sleep timer will go off.

En-35