Onkyo HT-r591 Connecting the AV Receiver, En-11, Connecting Your Speakers, Connections

Connecting the AV Receiver

Connecting Your Speakers

Connecting the Speaker Cables

The following illustration shows how to connect the speakers to each pair of terminals. If you’re using only one surround back speaker, connect it to the SURROUND BACK or FRONT HIGH L terminals.

Tip

•You can specify whether surround back or front high speakers are connected in the “Sp Config (Speaker Configuration)” menu (➔ page 42) or during Audyssey 2EQ® Room Correction and Speaker Setup (➔ page 27).

■Screw-type speaker terminals

Strip 1/2" to 5/8" (12 to 15 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown (Supplied speaker cables are already stripped).

1/2" to 5/8" (12 to 15 mm)

■Banana Plugs (North American and Brazilian models)

•If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.

•Do not insert the speaker code directly into the center hole of the speaker terminal.

Connections

Surround back/		Surround back/
	front high		front high	Surround		Surround
	right		left		right		left	Center

Front right Front left

En-11