1 | Turn on the AV receiver and the connected TV. |
| On the TV, select the input to which the AV receiver |
| is connected. |
2 | Set the speaker setup microphone at the Main |
Listening Position a, and connect it to the SETUP
MIC jack.
SETUP MIC jack
Speaker setup microphone
The speaker setting menu appears.
Note
•The
3 When you’ve finished making the settings, press
ENTER.
2EQ: Auto Setup | Audyssey |
SurrBk/FrontHigh |
|
< SurrBack > |
Perform the “Sp Config (Speaker Configuration)”
according to your speaker configuration:
–“SurrBk/FrontHigh” (➔ page 42)
4 Use q/wto select “Audyssey Quick Start” or “Audyssey 2EQ Full Calibration”, and then press
ENTER.
5
6
7
8
Press ENTER.
Audyssey 2EQ® Room Correction and Speaker Setup starts.
Test tones are played through each speaker as Audyssey 2EQ Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone during Audyssey 2EQ Room Correction and Speaker Setup, unless you want to cancel the setup.
If you select “Audyssey Quick Start”, you will go to step 8.
Place the speaker setup microphone at the next position, and then press ENTER.
Audyssey 2EQ performs more measurements. This takes a few minutes.
When prompted, repeat step 6.
Use q/wto select an option, and then press ENTER.
2EQ: Auto Setup |
| Audyssey |
<- Review Speaker Configuration | ||
Subwoofer | : | Yes |
Front | : | Small |
Center | : | Small |
Surround | : | Small |
Front High | : | None |
Surr Back | : | Small |
Surr Back Ch | : | 2ch |
Crossover | : | 100Hz |
Save
Cancel
The options are:
`Save:
Save the calculated settings and exit Audyssey 2EQ Room Correction and Speaker Setup.
`Cancel:
Cancel Audyssey 2EQ Room Correction and Speaker Setup.
Turning On & Basic Operations
Tip
•You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by using e/r.
9 Use q/wto select a target, and use e/rto change the setting.
After the results of Audyssey 2EQ have been saved, the menu will display the “Audyssey” (➔ page 46), “Dynamic EQ” (➔ page 46), “Dynamic Volume” (➔ page 47) settings.
Note
•When “Audyssey Quick Start” has been used for measurement, “Audyssey” cannot be selected.
•These settings are applied to all input selectors.
10Press ENTER.
11Disconnect the speaker setup microphone.
Note
•You can cancel Audyssey 2EQ Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone.
•Do not connect or disconnect any speakers during Audyssey 2EQ Room Correction and Speaker Setup.
•If the AV receiver is muted, it will be unmuted automatically when Audyssey 2EQ Room Correction and Speaker Setup starts.
•Changes to the room after Audyssey 2EQ Room Correction and Speaker Setup requires you run Audyssey 2EQ Room Correction and Speaker Setup again, as room EQ characteristics may have changed.
