Onkyo HT-r591 Before Using the Home Theater Speaker Package, Setting the Subwoofer Level, En-2

■Front

SKW-591

Status indicator

Off: Subwoofer in standby mode or disconnected from power source

Blue: Subwoofer on

With the Auto Standby function, the SKW-591 automatically turns on when an input signal is detected in standby mode. When there’s no input signal for

awhile, the SKW-591 automatically enters standby mode.

Before Using the Home Theater Speaker Package

Using the Rubber Stoppers for a More Stable Platform

We recommend using the supplied rubber stoppers to achieve the best possible sound from your speakers. The rubber stoppers prevent the speakers from moving, providing a more stable platform. Use rubber stoppers for

Setting the Subwoofer Level

To set the level of the subwoofer, use the OUTPUT LEVEL control. Set it so that bass

sounds are evenly balanced with the treble sounds from the other speakers. Because our ears are less sensitive to very low bass sounds, there’s a temptation to set the level of the subwoofer too high. As a rule of thumb, set the subwoofer level to what you think is the optimal level, and then back it off slightly.

■Rear

(North American)

OUTPUT LEVEL control

the center speaker.

Rubber stoppers

Wall Mounting

To mount the front/surround/surround back speakers

SKW-591

To AC outlet

This control is used to adjust the volume of the subwoofer.

LINE INPUT

This RCA input should be connected to the subwoofer pre out on your AV receiver with supplied RCA cable.

Bottom of the SKC-591N/SKC-591

vertically, use the keyhole slot shown to hang each speaker on a screw that’s securely screwed into the wall.

Keyhole slots for

wall mounting

(Asian)(Brazilian)

Note

•The Auto Standby function turns the subwoofer on when the input signal exceeds a certain level. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on your receiver.

Using the Floor Pads for Subwoofer

If the subwoofer is placed on a hard floor (wood, vinyl, tile, etc.) and playback is very loud, the subwoofer’s feet may damage the flooring. To prevent this, place the supplied pads underneath the subwoofer’s feet. The pads also provide a stable base for the subwoofer.

Pad

SKF-591 SKR-590/SKB-590

To mount the center speaker horizontally, use the two keyhole slots shown to hang the speaker on two screws that are securely screwed into the wall.

Keyhole slots for wall mounting

SKC-591N/

SKC-591

7-7/8" (200 mm)

Tip

•If the center speaker is tilted, loosen the screw on the declined side to move upward so that the speaker could be adjusted vertically.

En-2