Onkyo HT-r591 instruction manual Enjoying Home Theater, Connecting the Speakers, Subwoofer SKW-591

Wall

3/16" to 7/16" (5 to 10 mm)

Caution

• A mounting screw’s ability to support a

speaker depends on how well it’s anchored to the wall. If you have

hollow walls, screw each mounting screw into a stud. If there are no studs,

or the walls are solid, use suitable wall anchors. Use screws with a head

diameter of 5/16" (9 mm) or less and a shank diameter of 1/8" (4 mm) or less. With hollow walls, use a cable/pipe detector to check for any power cables or water pipes before making any holes.

•Leave a gap of between 3/16" (5 mm) and 7/16" (10 mm) between the wall and the base of the screw head, as shown (We recommend that you consult a home installation professional).

Enjoying Home Theater

The Home Theater means that you can enjoy surround sound with a real sense of movement in your own home — just like being in a movie theater or concert hall.

aFront left and right speakers (SKF-591)

They should be positioned facing the listener at about ear level, and equally spaced from the TV. Angle them inward slightly so as to create a triangle, with the listener at the apex.

dSurround back left and right speakers (SKB-590) These speakers further enhance the realism of surround sound and improve sound localization behind the listener.

Position them behind the listener about 2 to 3 feet (60 to 100 cm) above ear level.

eSubwoofer (SKW-591)

The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects) channel and bass from the satellite speakers when a crossover is specified. The volume and quality of the bass output from your subwoofer will depend on its position, the shape of your listening room, and your listening position. In general, a good bass sound can be obtained by installing the subwoofer in a front corner, or at one- third the way along the front wall, as shown.

e a b

cd

Connecting the Speakers

Speaker Connection Precautions

Read the following before connecting your speakers:

•Turn off your receiver before making any connections.

•Pay close attention to speaker wiring polarity.

Connect positive (+) terminals to only positive (+) terminals, and negative (–) terminals to only negative (–) terminals. If the speakers are wired incorrectly, the sound will be out of phase and will sound unnatural.

•Be careful not to short the positive and negative wires. Doing so may damage your amp.

Note

•When you connect the front high left and right speakers, prepare for it separately, or use the surround back left and right speakers.

Powered	Front right	Front left
subwoofer	speaker	speaker
	Center speaker
		Green
	Red	White

bCenter speaker (SKC-591N/SKC-591)

Position it close to your TV (preferably on top) facing forward at about ear level, or at the same height as the front left and right speakers.

cSurround left and right speakers (SKR-590) Position them at the sides of the listener, or slightly behind, about 2 to 3 feet (60 to 100 cm) above ear level. Ideally they should be equally spaced from the listener.

Corner position

1/3 of wall position

*Using the supplied RCA cable, connect the subwoofer’s LINE INPUT to your AV receiver’s

SUBWOOFER PRE OUT jack.

Brown Tan Blue Gray

Surround Surround Surround Surround

back left back right left right

speaker speaker speaker speaker

En-3