ADJUSTMENT STEP 1
Program the Travel Limits
Travel limits regulate the points at which the door will stop when moving up or down.
Adjust the position of the door by using the black and purple buttons. Black moves the door UP (open) and purple moves the door DOWN (close).
Figure 1
LED
Black Button
Purple Button
Setting the UP position:
1.Press and hold the black button until the LED starts flashing slowly, then release (Figure 2).
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door.
•Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system.
•NEVER use force adjustments to compensate for a binding or sticking garage door.
•After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with
To prevent damage to vehicles, be sure fully open door provides adequate clearance.
Figure 2 | LED |
|
2.Push and hold the black button until the door reaches the desired UP (open) position.
NOTE: Make sure the door opens high enough for your vehicle.
3.Push the door control or programmed remote control. This sets the UP (open) limit and begins closing the door (Figure 3).
4.Immediately when the door begins to close, press and release either the black or purple button. This will stop the door.
Setting the DOWN position:
5.Push and hold the purple button until the door reaches the desired DOWN (closed) position (Figure 4).
6.Once the door is closed, if there appears to be too much pressure on the door, you may toggle the door back and forth using the black and purple buttons to reach the desired closed position.
7.Push the door control or programmed remote control (Figure 3). This sets the DOWN (close) limit and the door should open.
Proceed to Set the Force.
BLACK
Push and hold until the door is at desired UP
position
PURPLE
Figure 3
OR
LOCK
LIGHT
Figure 4
LED
BLACK
Push either button to stop door at desired DOWN position
PURPLE
28