Attaching the Companion Board
(DP-XXXX and DP-XXXXP)
This door intercom product consists of two sub assemblies which must be attached to each other before the final assembly can be installed. In this guide the electronic sub assembly will be referred to as the “Companion Board” and the mechanical assembly will be referred to as the “Door Plate.” Review the following diagrams and assemble as shown.
Companion Board Connection Details
To Button
To Speaker
Microphone
Remove the plastic cap that covers the microphone compartment on the door plate. Place the microphone in the compartment and replace the plastic cap over the microphone. Note that the plastic cap will form a friction fit over the top of the microphone wires holding them snug against the outer compartment wall until they exit at the base as shown. Remove the mounting screws which are already attached to the bracket and use them to attach the companion board. The companion board should mount on the front side of the bracket so that the screws pass through the companion board before threading into the bracket.
Companion Board
Place pressure cap
over microphone
Attach button and speaker wires as shown
Attach Companion Board with mounting screws
Completed
Connect Telephone Entry Controller here (see following pages for details)
4
