Drill a 3/4” .hole
Push the IR receiver head
through the hole.
Push the IR receiver head
through the hole in the
tabletop mount.
Mount the IR receiver to the TV or on a surface within line of sight
of your remote control.
Remove the backing from the tape and attach the
IR receiver holster in the desired location.
Snap IR receiver head into the holster
as shown.
Push the IR receiver hole
mount and IR receiver head
back into the hole.
Push the IR receiver hole
mount and IR receiver head
back into the hole in the tabletop
mount.
Tosecure the mount, remove
the backing from the foam tape
on the bottom of the unit and
attach the mount to any flat surface.
Insert the IR receiver head
into the IR receiver hole mount. Insert the IR receiver head
into the IR receiver hole mount.
Mounting the IR receiver: Option 1 - Using the holsterMounting the IR receiver: Option 3 - Using the tabletop mountMounting the IR receiver: Option 2 - Using the hole mount
AB-500
TxBatt
Rew<<Play>FF>>
LearnStopPause
123
456
789
0
Power-/--
ChVol
LearnError
AllOff
Off
Select
TunerCDSat
VCRDVDTV
ChannelVision
TM
CVHANNEL ISIONTM
Input
IR-4000
IRcoaxengine
ToIRcoax
adaptor
IRemitter Pwr
VCR
IR-4101
IR-4000
Ch.3 output
IREmitter
IREmitter
TVset
DVDplayer CHANNELVISION
TM
E200IR2AB
ESeries
PartNo.HS-4
-WAYSPLITTER/COMBINER4
5MHz-1GHzAllPortDCpassing
CVHANNEL ISIONTM
IN/outOUT/in OUT/in
OUT/inOUT/in
DCBlock
DCBlock and
75ohm terminator
HS-4
DCPassing
splitter
AB-500
TxBatt
Rew<<Play>FF>>
LearnStopPause
123
456
789
0
Power-/--
ChVol
LearnError
AllOff
Off
Select
TunerCDSat
VCRDVDTV
ChannelVisionTM
AB-500
TxBatt
Rew<<P
lay>FF>>
LearnStopPause
123
456
789
0
Power-/--
ChVol
LearnError
AllOff
Off
Select
TunerCDSat
VCRDVDTV
ChannelVisionTM
IR-4101
IR-4101
Abasic IR system, like the one shown below, is often used when an
audio/videosignal is distributed to a remote TV location using the RF
outputof the device. The IR-4101 is located near the TV, allowing IR
signalsto be detected, and the IR-4000 is located near the audio/video
source,providing an IR emitter output.
Basic IR-on-coax Setup Using the IR-4101 with an E-series IR modulator