User Codes
User codes for
Replace x with # or * depending on the position of the #/* switch.
Key codes | Function |
xxx1 | Talk with DOOR 1 |
xxx2 | Talk with DOOR 2 |
xxWhen on a phone call: places call on hold & answers door
When not on a phone call: answers the last door station activated
x5 | Activate page out function | |
(the following codes work while you talk to the door) | ||
x71 | Activate STRIKE 1 | (can use AUX terminals or TE110DS module) |
x72 | Activate STRIKE 2 | (Requires TE110DS module) |
Examples: (assuming the
The user dials ## - they will be connected to the last door station that was activated. Pressing ## again will toggle to the other door.
The user dials ###1 - they will be connected to DOOR 1 (Then, while talking)
The user dials #71 - strike 1 will be activated.
The user dials ###2 - they will be connected to DOOR 2 (Then, while talking)
The user dials #72 - strike 2 will be activated.
Call Waiting functions
Situation: Doorbell is pressed when you are already on the phone.
You will hear: You will hear call waiting beeps, press ## (or **) to be connected.
Situation: You have placed the caller on hold and switched to the door intercom.
You will hear: Occasional beeps reminding you that a call is holding.
Situation: You are speaking to the door intercom when an incoming phone call is detected by the system.
You will hear: Beep, beep, pause... Beep, beep, pause... etc.
Situation: The doorbell is pressed at the same time as an incoming call is detected.
When you pick up the receiver: you will be connected to the incoming call.
You will hear: Beeps corresponding to the distinctive ring for the door intercom being activated.
5
