Chaparral Chaparral FS 1310 manual Displaying Hardware and Configuration Information

Configuring the Router

Displaying Hardware and Configuration Information

You can display the router’s hardware and configuration information. This is where you can see what version of the firmware you have. Chaparral technical support personnel may also request this information.

You can display the hardware and configuration information two ways:

✁Hardware information only

✁Hardware and configuration information

Table 3-4lists the configuration information that is available.

Table 3-4. Configuration information

Group	Field	What displays	Field	What displays
HOST	Topology	Loop or Point-to-Point
		based on the topology
		set in the Router
		Administrator software.
		If set to Loop, the router
		detects if it is attached
		to a public loop (router
		is attached to the FL-
		port of a switch) or a
		private loop.
	Node WWN	FC World Wide Name
		for node.
	Port WWN	FC World Wide Name
		for port.
	FC Addr	24-bit FC address or	AL_PA, if	Currently assigned
		None if the FC link is	the	value or None if the
		not active.	topology is	FC link is not
			LOOP.	active.
	Loop ID, if the	SOFT or a specific	Current	Currently assigned
	topology is	number as set in the		value if the
	LOOP.	Router Administrator		topology is LOOP,
		software.		or Inactive if the FC
				link is not active.
	Router LUN	SOFT, NONE, or	Current	Currently assigned
		specific number as set in		value or Inactive if
		the Router		the Router LUN is
		Administrator software.		set to NONE.
CHAN 0	Initiator ID	SCSI ID of router on	Ultra/U2	Hardware runs as
CHAN 1		Channel 0 as set in the		Ultra2.
CHAN 2		Router Administrator
		software.
	Termination	Hardware setting: ON	Term	Hardware supplies
		or OFF.	Power	termination power.

3-27