Char-Broil 10101480 manual Problem Possible Cause Prevention/Solution

Troubleshooting (continued)

Problem	Possible Cause	Prevention/Solution
Burner will not light	• Rotary knob rotates without clicking.	• Replace knob.
using ignitor.	• Sparking between ignitor and electrode.	• Inspect wire insulation and proper connection. Replace wire if
		insulation is broken.
	• See “GAS ISSUES:” on previous page.
Burner will not match	• Match will not reach.	• Use long-stem match (fireplace match).
light.	• Improper method of match-lighting.	• See “Match-Lighting” section of Use and Care.
Sudden drop in gas	• Out of gas.	• Check for gas in LP cylinder.
flow or low flame.	• Excess flow valve on regulator tripped.	• Turn off control knob, wait 30 seconds and light appliance. If flames
		are still low, turn off knob and LP cylinder valve. Disconnect
		regulator. Reconnect regulator and leak-test. Turn on LP cylinder
		valve, wait 30 seconds and then light appliance.
	• Vapor lock at coupling nut/LP cylinder	• Turn off knob and LP cylinder valve. Disconnect coupling nut from
	connection.	cylinder. Reconnect and retry.
Flames blow out.	• Low on LP gas.	• Refill LP cylinder.
	• Excess flow valve tripped.	• Refer to “Sudden drop in gas flow” above.
Flare-up.	• Grease buildup.	• Clean burner and inside of fryer body.
	• Excessive fat in meat.	• Trim fat from meat before grilling.
	• Excessive cooking temperature.	• Adjust (lower) temperature accordingly.
Persistent grease fire.	• Grease trapped by food buildup around	• Turn knob to OFF. Turn gas off at LP cylinder. Let fire burn out. After
	burner system.	fryer cools, remove and clean all parts.
Flashback...	• Burner is blocked.	• Turn knob to OFF. Clean burner. See burner cleaning section of Use
(fire in burner ).		and Care.
Unable to fill LP	• Some dealers have older fill nozzles	• The worn nozzles don’t have enough “bite” to engage the valve. Try
cylinder.	with worn threads.	a second LP dealer.
Cooking slower than	• Vapor Lock	• Turn off control knob and disconnect coupling nut from LP cylinder.
		Reconnect and retry.
expected	• Valve not properly aligned to burner	• Loosen control panel and valve. Be sure valve is centered top to
	• High wind conditions	bottom and left to right in burner . Tighten all components once
		proper alignment is achieved.
		• Relocate the appliance to a less windy area. Use Top Cover during
		cooking.

19