Ignitor Lighting
•Do not lean over appliance while lighting.
1. Turn ON LP gas cylinder.
2.Press and turn the control knob to ON.
3.Turn ROTARY IGNITOR knob rapidly.
4.If ignition does not occur in 5 seconds, turn the burner control knob OFF, wait 5 minutes, and repeat lighting procedure.
If ignition still does not occur, follow
WARNING
Turn control knob and LP cylinder OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the control knob OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
Do not lean over appliance while lighting.
1.Turn ON LP cylinder.
2.Swing match hole plate to expose match lighting hole. Place lit match into match lighting hole of appliance as pictured below. Make sure lit match is placed inside hole and near burner.
3.Push in and turn control knob to ON. Be sure burner lights and stays lit.
4.Once lit, swing match hole plate back to cover up match lighting hole. Caution: Plate maybe hot.
Control
Knob
Match
Match Lighting
HoleHole
Plate
Swing Plate to expose Matchlighting Hole
Match
View is from side of appliance
Burner Flame Check
•Light burner. Looking through viewing hole on top of appliance, you should see the flame height as shown below. Turn control knob from ON to OFF. The Flame height should decrease and then go out. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.
High Flame
Low Flame
Turning Appliance Off
•Turn control knob to OFF position. Turn LP cylinder off by turning
Ignitor Check
•Turn gas off at LP cylinder. Turn ignitor knob. "Click" should be heard each time at electrode. See "Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is off at LP cylinder before checking valve. Knob locks in OFF position. To check valve, first push in knob and release, knob should spring back. If knob does not spring back, replace valve assembly before using this appliance. Turn knob to ON position then turn back to OFF position. Valve should turn smoothly.
Hose Check
•Before each use, check to see if hose is cut, worn or kinked. Replace damaged hose before using applaince. Use only valve/hose/regulator specified by manufacturer.
NormalKinked
HoseHose
General Appliance Cleaning
•Meat Thermometer: Do not immerse or soak in water. Wash with warm soapy water and wipe dry.
•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of appliance lid and bottom. Rinse and allow to completely air dry.
Do not apply a caustic grill/oven cleaner to painted surfaces. A black surface improves the appliances performance.
•Plastic parts: Wash with warm soapy water and wipe dry. Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.
•Painted surfaces: Wash with mild detergent or
•Stainless steel surfaces: To maintain the high quality appearance, wash with mild detergent and warm soapy water and wipe dry with a soft cloth after each use.
9
