WARNING

Turn controls and gas source or tank OFF when not in use.

CAUTION

If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.

Main Burner Match-Lighting

Do not lean over grill while lighting.

1.Turn OFF all gas burner control valves.

2.Turn ON gas at LP cylinder.

3.Open lid during lighting.

4.Place match into match holder (hanging from side of cart). Light match, place into lighting hole on right or left side of firebox.

5.Push in and turn far right or far left knob to position. Be sure burner lights and stays lit.

6.If ignition does NOT occur in 5 seconds, turn the burner

control knob OFF, wait 5 minutes, and repeat the lighting procedure.

7.Light other burners by pushing knob in and turning to position. If your grill has two cooking zones, repeat steps 4

through 6 for the remaining section of the grill.

Warning:

Top cover must be open when side burner(s) is in operation.

Sideburner Ignitor Lighting

Do not lean over grill while lighting.

1.Turn OFF all gas burner control valves.

2.Turn ON gas at LP cylinder.

3.To ignite SIDEBURNER, open sideburner cover.

4.Turn sideburner knob to the position.

5.Push and hold ELECTRONIC IGNITOR button until the burner lights.

6.Once burner has ignited, turn knob to desired setting.

7.If sideburner does not light, turn knob to OFF, wait 5 minutes, then repeat lighting procedure.

Sideburner Match Lighting

Do not lean over grill while lighting.

1.Open lid during lighting. Turn ON gas at LP cylinder.

2.Place lit match near burner.

3.Turn sideburner knob to the position. Be sure burner lights and stays lit.

Burner Flame Check

•Remove cooking grates and troughs. Light burners, rotate

knobs from to . You should see a smaller flame in

position than seen on . Perform burner flame check on sideburner, also. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.

Turning Grill Off

•Turn all knobs to OFF position. Turn LP cylinder off by turning hand-wheel clockwise to a full stop.

Ignitor Check

•Turn gas off at LP cylinder. Press and hold electronic ignitor button. "Click" should be heard and spark seen each time between each collector box or burner and electrode. See "Troubleshooting" if no click or spark.

Valve Check

•Important: Make sure gas is off at LP cylinder before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LOW position then turn back to OFF position. Valves should turn smoothly.

Hose Check

Before each use, check to see if hoses are cut or worn. Replace damaged hoses before using grill. Use only valve/hose/regulator specified by manufacturer.

General Grill Cleaning

•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.

Plastic parts: Wash with warm soapy water and wipe dry.

Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.

•Porcelain surfaces: Because of glass-like composition, most residue can be wiped away with baking soda/water solution or specially formulated cleaner. Use nonabrasive scouring powder for stubborn stains.

•Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy water. Wipe dry with a soft nonabrasive cloth.

•Stainless steel surfaces: To maintain your grill’s high quality appearance, wash with mild detergent and warm soapy water and wipe dry with a soft cloth after each use. Baked-on grease deposits may require the use of an abrasive plastic cleaning pad. Use only in direction of brushed finish to avoid damage. Do not use abrasive pad on areas with graphics.

Cooking surfaces: If a bristle brush is used to clean any of the grill cooking surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It is not recommended to clean cooking surfaces while grill is hot.

8

Page 8
Image 8
Char-Broil 463250211 manual Sideburner Ignitor Lighting, Sideburner Match Lighting, Burner Flame Check, Turning Grill Off