Self-tapping screw | Char-Broil 463257010 specification

11

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

Note: some parts omitted for clarity of illustration

Door

Hinge Pin

Front brace	7mm flat	7mm lock	1/4-20x1½”
	washer	washer	screw

12

Inside of cart, insert left and right grease tray rails into slots beneath grease tray opening in upper back panel, shown A. Attach right and left rails under front brace with two #8x3/8” self-tapping screws, shown B.

Note: some parts omitted for clarity of illustration

A

B

Cart lower back panel

#8x3/8”

Right rail

self-tapping screw

Left rail

Right rail

Left rail

Grease tray opening

22

Image 22

Char-Broil 463257010 manual Self-tapping screw

Contents

Estimated assembly time 30 minutes Date Purchased Table of Contents This Grill is for Outdoor USE only Installation Safety Precautions California Proposition First Time Use TemperatureGrilling Guide Getting Started Lava Rock / Briquettes Direct Cooking Food SafetyGrilling Guide Grilling Indirect Cooking Usda Recommended Safe Minimum Internal Temperatures Grilling Guide Tips & Tricks Grilling Guide Cleaning Your Grill LP Cylinder Filling USE and CareLP Liquefied Petroleum Gas UL listed Overfill Protection UseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lighting Sideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame Check Very Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinder Limited Warranty All Other Parts Year from date of purchase Parts List Not Pictured Parts Diagram Rear AssemblyFront 20x1/2 screws, 7mm lock washers, Grill head Regulator hose Upper back panel Holes on fascia to Attach bezel Holes on fascia to Attach valve bracketFully tighten lower screws on upper back panel Sideburner valve, shown C Self-tapping screw Wire Heat shield Clarity of illustration Cylinder screw at rear of cart AA Battery Electronic Ignition Cap Troubleshooting Emergencies Possible Cause Prevention/Solution AUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA