Char-Broil 463262811 manual Rear of Shelf

	Insert flange on right side shelf into side shelf brackets on side of firebox, shown A.
7
	Attach rear of shelf using one 1/4-20x3/4”screw, 7mm lock washer, 7mm flat washer and 1/4” nut in upper hole; using one
	1/4-20x1½”screw, 7mm lock washer and 7mm flat washer in lower hole, shown B/C.

Attach front of shelf and fascia using two 1/4-20x3/4”screws, 7mm flat washers, 7mm lock washers and 1/4” nuts, and one #8x3/8” self-tapping screw with large flat washer, shown C/D/E.

Remove the four screws and washers factory attached to the Auto Clean valve bracket. Position Auto Clean valve bracket beneath right side shelf fascia so that valve stem comes through larger center hole in fascia. Align the four holes on valve bracket with the four holes on fascia. Secure using screws and washers that were removed from bracket, shown F.

Place the blank bezel over valve stem on front side of the fascia. Align small holes on bezel with the holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press control knob on to valve stem, shown G.

7mm lock

C

washer

7mm flat

Rear of Shelf

B

washer

A

1/4”nut

1/4-20x3/4” screw

7mm lock

washer

1/4-20x1½” screw

7mm flat

7mm lock

1/4”nut

7mm flat

washer

washer

washer

D

Back of main control panel

E

#8x3/8” tapping

1/4-20x3/4” screw

Igniter Switch

screw

large flat

washer

1/4-20x3/4”

7mm lock

washer

screw

1/4”nut

Note: Insert this screw from

7mm flat

the back of main control

panel

washer

F

G

Screws and Washers	#8-32x3/8” screw
removed from valve bracket

Auto Clean valve bracket

4mm lock washer

knob

bezel(blank)

valve stem valve stem

17