Char-Broil 463262811 manual Holes on fascia to Attach bezel

9

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

7mm flat		1/4-20x1½”
	7mm lock	screw
washer
	washer

10 First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Screws and Washers removed from valve bracket

Note: Use left and right holes on fascia to attach valve bracket

Sideburner fascia

Sideburner valve bracket

Install bezel with “OFF” at top.

Note: Use upper and lower

holes on fascia to

attach bezel

Control knob #8-32x3/8” screw

4mm

lock washer

Control knob bezel

Valve stem

19