Char-Broil 463263110 manual Temperature gauge stem Control panel, Knob Back of the panel

5

On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in lower hole, using one 1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer on each side.

Do not fully tighten screws until side shelf installation is complete in later steps.

Upper back panel

1/4-20x1½” 7mm lock 7mm flat

screw washer washer

6

Pull out the knobs from control panel. Insert temperature gauge stem into the biger hole above knob bezel,shown A. Make sure the gauge is pushed in as far as it will go, then push the gauge downward until it clips into the panel, as shown in B/C. Re-install the knobs.

Temperature gauge stem

Temperature gauge

Control panel Knob bezel

Knob

A

B

Back of the panel

C

16