Char-Broil 463741209 manual Attach side shelves with #10-24x1-3/4 machine screws

8

(A)Place firebox onto cart. Attach with #10-24x1-1/4" carriage bolt, 7mm ID, 16mm OD fiber washersand#10-24wingnut.

(B)Position heat shield as shown. Place burner assembly into firebox. Make sure venturi tubes and valves are correctly engaged. Place small end of venturi clipinto venturi tube and large part of clip around valve. If burner is not leveled from left to right, adjust the two screws attaching valveto control panel in step 8B. Place control knobs on valves as shown in figure (A). Place heat shield onto burner venturi tube, then insert burner/ heat shield through venturi holes on firebox. Make sure ignitor

wire go through the hole on heat shield and firebox as shown.
(C) Inside firebox, attach firebox and control panel with 5mm ID, 16mm OD fiber washers and #8 sheet metal screws	.
(D)Attach ignitor wire to electrode.

Heat Shield

Correctly assembled valve in burner tube and venturi clips

B

		B
		Venturi tube
Burner	Ignitor
	wire
Assembly		#10-24x1-1/4"
		Carriage Bolt
		Qty. 4
		Venturi clip

C

5mm	#8 Sheet Metal
Fiber washer	Screw
Qty. 2	Qty. 2

Firebox

#8 Sheet

Metal Screw

5mm

Fiber washer

A

Control knobs

Heat shield	Venturi clip
	Qty. 2

#10-24

Wing Nut

Qty. 4

7mm

Fiber Washer

Qty. 4

Ignitor wire D

9

Attach side shelves with #10-24x1-3/4" machine screws.

Shelf

Right side	Left side	#10-24x1-3/4"
		Machine Screw

Qty. 8 21