Operation
Color Adjustment
Dimmer Curves
Control Panel Lock
Program Upload
Continued from previous page
The COLOR setting determines how the COLORado™
1)Go to SET > Color.
2)Select OFF, RGBW, or UC.
Setting | Description | |
OFF | When R, G, and B are “255,” the output will be at its maximum. | |
RGBW | When R, G, and B are “255,” CAL2 will determine the output. | |
UC | When R, G, and B are “255,” the output will match that of fixtures from | |
previous generations. | ||
|
This setting determines how the output of the COLORado™
1)Go to SET > Dim.
2)Select a dimmer curve (Off, Dim1, Dim2, Dim3, or Dim4).
Setting | Description |
OFF | The output is proportional to the faders’ position (linear) |
Dim1 | The output is not proportional (fastest) |
Dim2 | The output is not proportional (fast) |
Dim3 | The output is not proportional (slow) |
Dim4 | The output is not proportional (slowest) |
This setting allows the user to activate or disable the control panel lock, which keeps
1)Go to KEY.
2)Select On/ Off.
When the control panel lock is active, the fixture will prompt the user to enter the password after 30 seconds of control panel inactivity or after turning on the fixture.
After being prompted to enter the password:
1)Press <UP>, <DOWN>, <UP>, <DOWN>, and <ENTER>.
This option allows the user to copy the custom programs of one COLORado™
1)Configure and connect the fixtures in a Master/Slave arrangement, where the master unit has the custom programs you want to transfer onto the slave units.
2)At the master unit, go to SET > UPLD.
3)When prompted, enter the master access password as shown in Control Panel Lock.
4)Wait for the upload process to finish before disconnecting the fixtures.
During and after the upload, the master and slave units will visually indicate the status of the process, as follows:
Color | Meaning |
Yellow | The upload process is running |
Red | The upload failed due to an error |
Green | The upload finished successfully |
Continues on the next page
COLORado™ |
