1.BEFORE YOU BEGIN
What is included
1x Intimidator™ Scan LED
1x Power Cord
1x Warranty Card
1x User manual
Unpacking Instructions
Immediately upon receiving the fixture, carefully unpack the carton, check the contents to ensure that all parts are present and that have arrived in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the event that the fixture must be returned to the factory, it must be returned in the original factory box and packing.
Symbols
This paragraph contains critical installation, configuration or operation information. Failure to comply with this information may render the system partially or completely inoperative, cause damage to the system or cause harm to the operator/user/technician
This paragraph contains important installation or configuration information. Failure to comply with this information may prevent the system from functioning correctly.
This paragraph reminds you of useful, although not critical, information.
AC Power
This fixture has an
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a 0% to 100% switch.
To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its average current draw under normal conditions.
Before applying power to a fixture, check that the source voltage matches the fixture’s requirement. Check the fixture or device carefully to make sure that if a voltage selection switch exists, it is set to the correct line voltage you will use.
Always connect the fixture to a circuit with a suitable electrical ground.
Intimidator™ Scan LED | 1 |
