any doubt about the safety issues involved, have a qualified, certified, arborist/tree surgeon do the work for you.
21.WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from
22.WARNING: We recommend that people with pacemakers not use this tool. This tool produces strong electromagnetic fields that can cause interference or failure of the pacemaker. People with pacemakers should consult their physician(s) for ad- vice.
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 11 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 12.
To Attach Or Replace The Chain Guide Rail And Chain:
1.WARNING: Make sure to turn the On/Off Trigger (25b) to its “OFF”position and un- plug the Electric Cord (23) from its electrical outlet before performing this procedure.
2.Remove Screw (7) and Nylon Insert Nut (67) from the Chain Cover (46) with the tools provided. Note the Blade Guide Pin (62) and Bolt (6) shown in Figure B. Make sure the Guide Pin is positioned near the rear (left end) of the slot. Make certain that the oil port is open and free of debris.
3.Place the Chain (57) around the rear of the Chain Gear (45), making certain that the teeth along the top of the Chain point forward.
4.Place Guide Bar (52) with the center slot over the threaded end of the Bolt (66), and fixed pin (molded into the Front Cover (42)), as in Figure C. The Blade Guide Pin (62) goes into the lower hole in the blade. These steps may be easier with assis- tance.
REV 05/05
SKU 02810 | For technical questions, please call | Page 6 |