FIGURE B
5.Replace the Chain Cover (46), and tighten the Nylon Insert Nut (67) so that the Cover is snug, but not tight. (See Figure D, next page.)
6.Pull gently up on the tip of the Guide Bar (52), while turning the Blade Adjustment Screw (61) clockwise (photo 005.) Because the saw is light in weight, this is easier
if someone holds the handle. Do not overtighten the Chain. There should only be about 1/4” of space when the Chain is pulled upward at the center of the Guide Bar. Lightly oil the entire Chain (57). (See Figure C.)
FIGURE C
7.When finished, tighten the Nylon Insert Nut (67) securely, and replace Screw (7). Check the Chain tension after initial operation of the saw. It may need adjustment.
REV 05/05
SKU 02810 | For technical questions, please call | Page 7 |
