OPERATING INSTRUCTIONS
The Safety Brake:
1.The Safety Brake is activated when the back of the operator’s hand pushes against the back of the Protect Plate (17). When activated, the Chain Saw will stop auto- matically, and the On/Off Trigger (25b) should be manually released. Next, pull the Protect Plate (17) back to its initial position in order to restart the Chain Saw.
NOTE: If the Protect Plate (17) is not pulled back to its initial position, the Chain Saw will not operate. (See Figure E.)
2.To check for proper operation of the Safety Brake, disconnect the Chain Saw from its electrical power outlet and push the Protect Plate (17) forward. Pull on the Chain
(57)with your hand protected by heavy work gloves. The Chain Saw should be automatically locked in its “OFF” mode.
PROTECT PLATE (17) | HANDLE (47) | ON/OFF TRIGGER (25b) |
CHAIN (57)
ELECTRIC
CORD (23)
| CARBON BRUSH (4) |
FIGURE E | CARBON BRUSH HOLDER (5) |
CARBON BRUSH HOUSING (6) |
To Start The Chain Saw:
1.Make sure the On/Off Trigger (25b) is in its “OFF” position. (See Figure E.)
2.Plug the Electric Cord (23) into a grounded, 120 volt, electrical outlet.
(See Figure E.)
3.Use both hands to firmly grasp the handle portion of the Motor Housing Handle (1) and Handle (47). (See Figure E.)
4.Before starting the Chain Saw, make sure nothing is in contact with the Chain (57).
(See Figure E.)
5.Make sure the Protect Plate (17) is pulled back towards your body until it “clicks” and locks in place. (See Figure E.)
6.To start the Chain Saw, push the Safety Switch on the On/Off Trigger (25b) and squeeze the On/Off Trigger. (See Figure E.)
7.Release the On/Off Trigger (25b) to stop the Chain Saw. WARNING: Firmly hold the Chain Saw with both hands until the Chain Saw completely stops. (See Figure E.)
SKU 02810 | For technical questions, please call | Page 9 |
