tant information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
6.Have the equipment serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the equip- ment is maintained. Do not attempt any service or maintenance proce- dures not explained in this manual or any procedures that you are un- certain about your ability to perform safely or correctly.
7.Store equipment out of the reach of children.
8.Follow scheduled engine and equip- ment maintenance.
Refueling Precautions:
a. Do not smoke, or allow sparks, flames, or other sources of ignition around the equipment, especially when refuelling.
b. Do not refill the fuel tank while the engine is running or hot.
c. Do not fill fuel tank to the top. Leave a little room for the fuel to expand as needed.
d. Refuel in an exterior,
Basic Specifications
| Type | 89+ Octane unleaded | |
Fuel | gasoline. | ||
| |||
| Capacity | 0.6 US Gallons | |
|
|
| |
| Type | SAE 30W Above 32° F | |
Engine Oil | SAE | ||
| Capacity | 0.2 QT. |
Run Time @ 50% | Approximately 4 Hours | |
Load | (with full tank). | |
Sound Level | 93 dB | |
Power Output | 950 W Rated, 1000 W | |
Peak | ||
| ||
| 120 V ~ 7.9 A Rated | |
Receptacles | Duplex Receptacle 12 V | |
| DC 65 Receptacle. |
Note: Additional specifications found in the Technical Engine Specifi- cations chart in this manual.
The emission control system for this engine is warranted for standards set by the U.S. Environmental Protection Agency and by the California Air Resources Board (also known as CARB). For warranty information, refer to the last pages of this manual.
At high altitudes, the engine’s carburetor, governor (if so equipped), and any other parts that control the
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
SKU 65588 | For technical questions, please call | Page 6 |
