to the Battery Guard Plate, using two Bolts with Lock Washers (46).
(See Figure B.)
FIGURE B
NEGATIVE BATTERY CABLE |
|
12 VDC BATTERY | POSITIVE BATTERY CABLE |
(NOT INCLUDED) | |
| BATTERY GUARD PLATE (44) |
BATTERY BRACKET (47) |
|
| BATTERY TRAY (48) |
BOLT WITH LOCK WASHER (46) |
|
6.Connect the Engine’s Positive Battery Cable (RED +) to the Battery’s positive (+) terminal. Then connect the Engine’s Negative Battery Cable (BLACK
TO ATTACH THE WHEEL ASSEMBLY
1.With additional assistance, and a proper lifting device, raise the left side of the
Generator about 6 to 8 inches off the floor surface.
2.Attach the two Axle Brackets (53) to the lower Frame (42), using two Bolts (52) and two Lock Washer Nuts (13) for each Axle Bracket (See Assy. Diagram).
3.Slide the Axle (49) through the two Axle Brackets (53). (See Assy. Diagram.)
4.Insert one Wheel (50) onto each end of the Axle (49). (See Assy. Diagram.)
5.Secure the Axle (49) and Wheels (50) in place, using four Pins (51).
(See Assy. Diagram.)
INSTALLATION INSTRUCTIONS
1.IMPORTANT: Electrical and other permits may be required for the installation of emergency or portable power systems. Make sure to investigate the local building and electrical codes before installing this unit.
2.Locate the Generator (outdoors only) where cooling air is readily available. Locate the Generator so that the air inlets and outlets are not blocked by obstructions such as bushes, trees, walls, snow drifts, etc. Locating the Generator in the path
SKU 66603 | For technical questions, please call | Page 11 |
