Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Turn the Power Switch (44) of the Tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
1.BEFORE EACH USE, inspect the general condition of the Tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
The Sanding Sheet (504) should not be dull or contain excessive debris
The Angled Scraper (4) and cutting Blades (501, 503) should be clean and sharp.
2.After Use, clean external surfaces of the tool with clean cloth.
3.If you notice decreased performance, have the unit serviced and Carbon
Brushes (40) replaced by a qualified technician.
4.
WARNING! If the Power Cord (46) of this Tool is damaged,
it must be replaced only by a qualified service technician.
PLEASE READ THE
FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he
or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
SKU 67256 | For technical questions, please call | Page 11 |
