Chicago Electric 67256 operating instructions Figure D

be mounted at angles up to 90° left or right.

Angled Cutter Blade (501)

Figure D

Note: The long Angled Cutter Blade (501) should only be used in the straight ahead position. (See Figure D.)

Figure E	Place Large
	Washer,
	cupped side
	down

Torque to 10 ft-lbs

Figure F

4.Tighten the cap screw onto the Spindle using the provided hex key.

Torque firmly (approximately 10 ft-lbs). After securing, the attachment should not move on the spindle. If it can move with the power off, remount it, making sure that the holes on the attachment line up with the pins on the spindle. Tighten the cap screw securely.

3.Slide the Small Washer (2), then the

Large Washer (3) onto the the Cap

Screw (1). Make sure the cupped side of the Large Washer is toward the tool. While holding the attachment over the pins on the tool, thread the Cap Screw in place. (See Figure E.)

REV 10e

SKU 67256 For technical questions, please call 1-800-444-3353. Page 9