Instructions for the User
4.9.1 How to use this program
Use the knob to select the manual program.
The display shows "- - - - " to indicate that there are no cooking parameters present, and the number of the program (P10).
Press START or keep it pressed to increase the cooking temperature; each time START is pressed the temperature increments by 1°C (from 50° to 300°), or hold START down for increments of 5°C.
Press STOP or keep it pressed to increase the cooking time from 1 min. to 99 min. if you require a timed cooking operation, or set "InF" if an indefinite cooking time is required.
Release STOP and preheating will start automatically after 5 seconds; the oven will preheat to the set cooking temperature.
N.B. – When the cooking process is over, to repeat the same program do not turn the knob and press START again.
4.10 Rapid cooling
The oven has a special function which allows its interior to be cooled quickly. To activate this function, turn the function selector to "0", open the door and press the START key for at least 2 seconds. The fans inside the oven will come into operation with the heating elements off. To stop the function, press the STOP key.
4.11 Key to the oven's beep sounds
All the beep sounds the oven emits are different from each other, in order to allow the user to identify exactly what the oven is doing.
Parameter setting/modification menu = 1 single beep
End of preheating and pause before start of cooking = 5 beeps followed by a pause of 2 seconds.
Cooking start = 2 single beeps
Door open during preheating and cooking = continuous beep End of cooking = 3 beeps followed by pause of 4 seconds.
4.12Possible error messages on the display
The display is able to show two different types of error
4.12.1 Err3
This message appears whenever the software detects a sensor malfunction.
4.12.2 Err1
This message appears whenever the software detects that the sensor connector is not properly connected to the electronic circuit board or has
33
