Smeg ALFA135V6 Modifying a previously edited program, Manual cooking, Instructions for the User

Instructions for the User

above, or at the program temperature for cooking operations at below 100°C. After 20 minutes, the oven switches off.

N.B. - during preheating and cooking, whenever the door is opened the message "door" will appear on the display and a beep will sound to warn the user that the door must be closed while these operations are in progress.

4.8 Modifying a previously edited program

To modify one of the programs, turn the knob to one of the programs from P1 to P14 edited previously.

The parameters saved earlier will appear on the display. Hold down STOP for 2 seconds.

The display shows U t°C.

Press START to display the cooking temperature.

Press START or keep it pressed to increase the cooking temperature; each time START is pressed the temperature increments by 1°C (from 50° to 300°), or hold START down for increments of 5°C.

Press STOP to move on to displaying the next parameter The display shows U Ct.

Press START to display the cooking time.

Press START or keep it pressed to increase the cooking time (from 1 min. to 99 min.).

Press STOP to move on to displaying the next parameter The display shows U Ht only if Ut°C is set > 150°C Press START to display the humidification cycles.

Press START or keep it pressed to increase the number of humidification cycles (from 0 to 6 cycles where 0 means conventional fan-mode cooking without the aid of humidification).

Press STOP to complete the program editing procedure. The display shows UEnd.

The parameters set are now saved in the chosen program.

4.9 Manual cooking

Use the knob to select the manual program.

The special feature of this user-editable program is that the cooking parameters set are not retained in the memory when the knob is turned to any other position.

This means that an "empty" program is always immediately available for quick, easy editing.

32