Uniden D1484-3 manual Important Information, Troubleshooting, Programming a Security Code, English

Programming a Security Code

With the phone in standby, open the menu; select Answering Setup, then select Security Code. Use the number keypad to enter a two-digit security code (01 to 99). Press Menu/select when you’re finished.

## Remember to make a note of your new security code!

Dialing In to Your System

1.Call your phone number from any touch-tone phone, and wait until the system answers.

xxIf you have the Ring Time set to Toll Saver, the system answers after 2 rings if you have new messages and 4 rings if you don’t. You can hang up during the third ring.

xxIf the system is turned off, it answers after 10 rings and beeps sound.

2.During the greeting or beeps, press 0 and immediately enter your security code. If you enter it incorrectly 3 times, the system hangs up and returns to standby.

3.The system announces the time, the number of messages in memory, and a help prompt. It beeps to let you know it’s waiting for a command; enter a 2-digit command from the chart.

## If you don’t press any keys for 15 seconds, the system hangs up and return to standby.

01	Repeat message
02	Play message
03	Skip message
04	Delete message
05	Stop playback
06	Turn the system on
09	Turn the system off
10	Hear help prompts

Important Information

Troubleshooting

General problems	Possible solutions
	xxCheck the telephone cord connection.
I can’t make or receive	xxDisconnect the base AC adapter. Wait a few
calls.	minutes, then reconnect it.
	xxMake sure the base is plugged in.
The handset won’t ring.	xxMake sure the ringer is turned on.
The handset is not	xxCharge the battery for 15-20 hours.
working.	xxCheck the battery connection.
The handset won’t	xxLet calls ring twice before answering.
display CID information.	xxMake sure your CID service is active.

English - 13