COMPONENTS
Power Switch (44)
OFF |
|
ON | Spindle (5) |
Tool |
|
Angled Scraper (4) | Sanding |
| Pad |
| (502) |
Angled Cutter |
|
Blade (501) |
|
Half Moon Cutter Blade (503) | Sanding |
| Sheets (504) |
|
| Cap Screw (1) |
|
| Small Washer (2) |
| Large Washer (3) | |
Hex Wrench (505) | (not shown): | |
|
| Two replacement |
Figure A | Carbon Brushes (40) |
|
ASSEMBLY Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch (44) off and unplug the tool from its electrical outlet before assembly.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
1.Turn the Power Switch off and unplug the tool.
Attachment | Figure B |
[Angled | |
Scraper (4)] |
|
Spindle
(5)
2.Place the attachment over the Spindle (5), shoulder facing away from the tool. Line up the holes on the attachment with the pins on the Spindle shoulder.
(See Figure B.)
Figure C
Attachments (with the exception of the long Angled Cutter Blades) may
REV 10e
SKU 67256 | For technical questions, please call | Page 8 |
