Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY
FROM ACCIDENTAL OPERATION:
Release the Trigger and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED. Moving guards must move freely and close instantly.
To Remove or Install a
1.Raise the Saw if it is locked down by pushing down on it and pulling out the Lock Ball (21).
2.Open the Movable Guard (40) and tighten the Bolt (39) to secure it while working on the Wheel.
3.Push in the Spindle Lock Pin towards the Fixed Guard as shown in Figure F. Rotate the wheel until the Lock Pin slides into place.
Spindle
Lock Pin
(61)
Figure F: Spindle Lock Pin
4.While continuing to hold down the Spindle Lock Pin, use the Wrench (92) to remove the Arbor Bolt (41).
Wheel (44)
Arbor
Bolt (41)
Spindle Lock
Pin (61)
Wrench
(92)
Figure G: Removing Cut-off Wheel
5.Remove the Arbor Bolt (41), Arbor Washer (42), Outer Flange (43), and
Outer | Arbor | Arbor | |
Wheel (44) | Flange (43) | Washer (42) | Bolt (41) |
Figure H: Removing Wheel
Page 6 | For technical questions, please call | SKU 68104 |
