
9. To prevent accidents, turn off the Saw, remove the Key, and unplug the Tile Saw after use. Clean, then store the Saw indoors out of children’s reach.
General Operating Instructions
1. Fill the Water Tray with clean water up to the Fill Rim (see Figure H on page 11) before every use.
CAUTION: Water level must be kept above lip of pump basin at all times during operation.
2. Adjust the Miter, Bevel, and Depth settings as needed, see previous page. Lock all settings in place.
3. Place the workpiece on the Table and firmly against the Miter Gauge and Fence.
4. Make sure the workpiece is clear of the Blade, then dry your hands, plug in the Saw, insert the Key and turn the Power Switch to the ON position.
5. Make sure the pump is supplying enough water to the Blade. If needed, dry your hands, unplug the Saw, adjust the Pump′s flow control, dry your hands again, and plug the Saw back in.
6. Let the Blade build up to full speed before cutting.
7. Hold the material firmly against the rip guide and feed the material into the Blade.
8. When the cut is made, turn the Saw OFF. Wait for the Blade to come to a complete stop before removing any part of the workpiece.
SAFETY
SETUP
OPERATION
MAINTENANCE
Page 14
Figure N: Straight Cut
Figure O: Miter Cut
Figure P: Bevel Cut |
|
For technical questions, please call | Item 69275 |