Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool to its “OFF” position, remove the key, and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
SAFETY
Cleaning, Maintenance, and Lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose hardware, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
2.AFTER USE, wipe external surfaces of the tool with clean cloth. Also, clean the following after every use, and as needed during extended use:
•Rails
•Particle Tray (see page 11)
•Water Tray (see page 11, empty out sediment and water)
•Pump filter and housing (see page 11,
can often be rinsed off without opening pump).
3.If Blade is out of alignment, Table does not slide smoothly or other issues interfere with smooth operation, have the saw serviced by a qualified technician before further use.
4.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
SETUP
OPERATION
MAINTENANCE
Item 69275 | For technical questions, please call | Page 15 |
