Page 10 For technical questions, please call 1-800-444-3353. SKU 91780
6.
Figure 9
Solenoid Assembly (34w)
Socket Cover (2s)
Socket (6s)
Switch
Assembly
(35w)
Lift the Socket Cover (2s) on the
Solenoid Assembly (34w) and insert the
Switch Assembly (35w) connector into
the Socket (6s). Disconnect the Switch
Assembly when not in use.
Note: The attachment of the Motor Cables
(17s & 24s) determines the way the
toggle button on the Switch Assembly
(35w) operates. After the unit is mounted
and powered, check the direction of the
Power In and Power Out on the Switch
button. To change the direction on the
Switch, disconnect the Battery Cables
from the battery, switch the Motor Cable
connections on the Motor terminal, then
reconnect the Battery Cables.
Preparing the Wire Rope
BEFORE FIRST USE:
1. The wire rope must be properly coiled
under tension to be able to support a
load without damage.
2. Uncoil the wire rope, except for 5 full
wraps.
3. Recoil the wire rope back into the winch
under at least 500 lb. of tension.
OPERATION Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
The instructions that follow are
basic guidelines only and cannot
cover all situations encountered
during use. The operator and
assistants must carefully plan
usage to prevent accidents.
1. Examine the wire rope. Do not use the
winch if the wire rope is frayed, kinked or
damaged.
2. Fully charge the vehicle’s battery.
3. Check the winch’s electrical connections.
All connections must be tight and clean.
4. Put the vehicle’s transmission in Neutral.
5. If the vehicle where the winch is mounted
is not supposed to move, engage the
emergency brake and block the wheels
using wheel chocks.
6. To pull out the wire rope, move the Cam
Ring (11w) to the OUT position, slide the
loop of the Hook Strap (46w) over the
hook, then pull on the Hook Strap to pull
out the wire rope.
WARNING! Leave at least ve full
turns of wire rope on the drum.