Mounting a Grinding Wheel
Refer to the Assembly Drawing on page 10.
FIGURE 3
Grinding Wheel
Cover (11B)
Top Housing (4B)
Lock Stop (6)
1.Raise the Top Housing (4B) and lock it in the up position by tightening the Lock Stop (6).
2.Remove the four screws holding the Grinding Wheel Cover (11B). Set the cover aside.
FIGURE 4
Grinding
Wheel (8)
Grinder Lock Cap (9)
to the human eye by hanging it up by the central hole and tapping it with a non metal object (ie: screwdriver handle). If it is in good condition it will produce a metallic sound. A dull sound indicates a crack or break.
5.Replace the Grinder Lock Cap (9).
6.Replace the Grinding Wheel Cover (11B).
7.Release the Lock Stop (6) and lower the Top Housing (4B).
8.Never operate tool without the Grinding Wheel Cover in place.
3.Unscrew the Grinder Lock Cap (9) that holds the Grinding Wheel (8) in place.
4.Install the new wheel on the Grinding
Wheel Base (7), making sure it fits properly.
Note: Do not use a grinding wheel if it is chipped, cracked, or worn. You can check if the wheel has cracks not visible
|
| REV 10c |
SKU 93213 | For technical questions, please call | Page 9 |
