FIGURE 10
FIGURE 11
3.Slowly lower the grinding wheel as shown in FIGURE 10. If you notice slight errors in your settings, turn off the unit and unplug it before you make your adjustments.
Note: A good grind occurs when the contact between the wheel and the teeth are gradual and smooth. Do not stop too long on any tooth.
4.After sharpening one tooth, turn off the machine. Lift the Top Housing (4B), release the Handle (34), and move the chain so that the next link is positioned in the Chain Stop (23). Tighten the Handle (34). Turn the machine back on and continue sharpening the next tooth. Repeat this process until you have sharpened all of the links set up for this angle.
Lock Wheel (18)
5.After you finished sharpening all of the teeth set for your current angle, turn off the machine by pushing the Switch (5B) and unplugging the unit. See FIGURE 11
6.Loosen the Lock Wheel (18) and reset the angle so that the first tooth that hasn’t been sharpened is positioned against the Chain Stop (23) and locked in, as explained on page 6.
7.As you did with the first half of the chain, be sure to lower the Top Housing (4B) so that the Grinding Wheel (8) skims the chain tooth, and lock it in place. See page 6. Follow all of the steps on page 6 double checking everything before you plug in the machine and turn it on again.
WARNING! Remember to turn off the machine and unplug it if you need to make any adjustments.
8.After you repeat all of the steps under Sharpening on page 7, your chain is ready to be mounted on your saw.
SKU 93213 | For technical questions, please call | Page 12 |
