Chicago Electric 93853 operating instructions Troubleshooting, Please Read the Following Carefully

		TROUBLESHOOTING
Problem		Possible Solution
Chisel installs with difficulty.	Make sure the Chisel shank, Front Cap, and Slider are free of debris
	and lightly oiled or greased. (See page 12.)
Tool does not run.	1.	Make sure the Power Switch is in its “ON” position. (See page 11.)
	2.	Make sure the Power Cord & Plug is connected to a working 120 volt,
		grounded electrical outlet. (See page 9.)
	3.	Make sure the Power Cord & Plug is not damaged.
	4.	Make sure the tool is filled with approximately 1-1/4 ounce of #3
		Lithium-base grease. (See page 11.)
	5.	Check the Motor Carbon Brushes for excessive wear and/or debris.
		Replace or clean if necessary. (See page 14.)
	6.	Have a qualified service technician service the tool.
Tool does not stop.	1.	Make sure the Power Switch is in its “OFF” position. (See page 11.)
	2.	Immediately disconnect the Power Cord & Plug from its electrical
		outlet, and have a qualified service technician service the tool.
Poor cutting efficiency.	1. Make sure the Chisel is clean and sharp.
	2.	Adjust the Variable Speed Control Dial for the type of work being
		done. (See page 12.)
	3.	Apply moderate pressure only. Allow the tool to do the cutting without
		being forced.
	4.	Check the Motor Carbon Brushes for excessive wear and/or debris.
		Replace or clean if necessary. (See page 14.)
	5.	Have a qualified service technician service the tool.
Tool overheats and suddenly	1. Make sure the tool is filled with approximately 1-1/4 ounces of #3
stops running.		Lithium-base grease. (See page 11.)
	2.	Make sure the Motor Air Vents are clean and free of debris. (See
		page 14.)
	3.	Have a qualified service technician service the tool.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT

OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 93853 For technical questions, please call 1-800-444-3353 PAGE 16